Aller au contenu principal

Introduction

Use this guide to replace the battery on an Alienware 17 R2 laptop.

Your laptop may need a new battery if it will not hold a charge or will not turn on without being connected to the charger. While replacing the laptop battery might fix this issue, it may not be a permanent solution. Please be cautious if the battery appears to be swollen.

Some knowledge and understanding of computer motherboards will be beneficial, however, minimal repair skill is required. Before beginning, make sure to power down the computer completely and disconnect it from any external power source.

  1. Be sure the laptop is turned off.
    • Be sure the laptop is turned off.

    • Unplug the laptop from the power adapter.

    • Place the laptop face down on a hard surface.

  2. Remove the two screws on the access door. Pull up the access door and slide it off. Pull up the access door and slide it off.
    • Remove the two screws on the access door.

    • Pull up the access door and slide it off.

  3. Carefully unplug the black cord with the yellow tag to disconnect the battery. Carefully unplug the black cord with the yellow tag to disconnect the battery. Carefully unplug the black cord with the yellow tag to disconnect the battery.
    • Carefully unplug the black cord with the yellow tag to disconnect the battery.

  4. Disconnect the four cables from the motherboard.
    • Disconnect the four cables from the motherboard.

    • Be careful when disconnecting the cables. Their connectors are very fragile and if too much force is applied, they can come out of the PCB, causing permanent damage.

  5. Remove the two 2.5mm x 18mm screws from the top of the laptop. Remove the four 2.5mm x 10mm screws from the left and right sides of the laptop. Remove the two 2.5mm x 10mm screws from the top corners.
    • Remove the two 2.5mm x 18mm screws from the top of the laptop.

    • Remove the four 2.5mm x 10mm screws from the left and right sides of the laptop.

    • Remove the two 2.5mm x 10mm screws from the top corners.

    • Remove the eight 2.5mm x 8mm screws from the middle of the laptop.

  6. Slowly separate the palm rest from the laptop. Disconnect the power cord from the laptop to the palm rest. Remove the palm rest.
    • Slowly separate the palm rest from the laptop.

    • Disconnect the power cord from the laptop to the palm rest.

    • Remove the palm rest.

  7. Unplug the two cables from the laptop.
    • Unplug the two cables from the laptop.

  8. Remove the six 2.5mm x 5mm screws. Gently lift up and remove the battery. Gently lift up and remove the battery.
    • Remove the six 2.5mm x 5mm screws.

    • Gently lift up and remove the battery.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

Luis Garcia

Membre depuis le 20/09/2017

402 Réputation

4 tutoriels rédigés

Équipe

2 commentaires

Many thanks for a decent write up. My only observation was that I don't know why there was a need to unplug the power to the palm rest and fully remove it? You have access to the battery once the palm rest is lifted. Good write up non the less

mark dale - Réponse

I agree with Mark. No need to unplug the cable to the palm rest.

lrshapiro -

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 4

7 derniers jours : 46

30 derniers jours : 172

Total : 6,800