Introduction

This guide will teach the user how to remove a damaged SLR lens mount on the Cannon AE-1. The SLR lens mount allows the user to connect different lens to the Canon AE-1.

Pièces

Aucune pièce nécessaire.

Remove the first set of two #00 phillips screws from the lens outer casing
  • Remove the first set of two #00 phillips screws from the lens outer casing

    • The first set of screws are located on the front and bottom of the lens casing

    • Pull the screws out and set them aside so as not to lose them

Ajouter un commentaire

Remove the remaining two #00 phillip screws from the lens outer casing
  • Remove the remaining two #00 phillip screws from the lens outer casing

    • The second set is located left and right side of the lens casing

    • Pull the screws out and set them aside so as not to lose them

Ajouter un commentaire

  • Once the screws have been taken out, you may simply remove the lens casing by pulling it away from the body of the camera.

Ajouter un commentaire

  • Remove the four #00 phillips screws from the SLR Lens Mount

Ajouter un commentaire

  • After the screws have been removed, pull the SLR Lens Mount away from the body of the camera

  • Be aware that a pin will fall out when the SLR Lens Mount is removed.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Joe Blumberg

Membre depuis le 04/10/2011

147 Réputation

1 tutoriel rédigé

Équipe

UW Stout, Team 5-1, Zhou Fall 2011 Membre de l'équipe UW Stout, Team 5-1, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G1

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 9

30 derniers jours : 49

Total : 7,687