Introduction

This guide details how to replace the flash bulb of this camera.

Locate the battery cover at the bottom of the camera.
  • Locate the battery cover at the bottom of the camera.

  • Pull down on the black tab to open the cover.

Ajouter un commentaire

Push the grey tab on the right side of the battery.
  • Push the grey tab on the right side of the battery.

  • Remove the battery from the slot.

Ajouter un commentaire

  • Using the Phillips screwdriver, unscrew the two 4.9mm Phillips head screws which are located underneath the flash.

Ajouter un commentaire

  • Remove the covering.

Ajouter un commentaire

  • Use the tweezers to remove the excess glue around the wiring. This will allow you to cut the wire and remove the light in the next step.

Ajouter un commentaire

  • Use the wire cutters to cut the wiring connected to the flash.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Jordan Rabold

Membre depuis le 14/04/2014

628 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 12-33, Maness Spring 2014 Membre de l'équipe Cal Poly, Team 12-33, Maness Spring 2014

CPSU-MANESS-S14S12G33

4 membres

7 tutoriels rédigés

how do you reverse step 6 - cutting the wires?

jeremyyoung - Réponse

You dont tell how to make sure capacitors are discharged before changing the flash ? and do you know what is the replacement number of the flash bulb itself ?

jackqc09 - Réponse

No parts required? So I can repair my flash not having to buy a new bulb? haha Please, I need the link from where I repair my burned built-in flash :/

gustavoaleme - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 24

Total : 2,650