Introduction

This guide shows the user how to take out the logic board, and therefore have the opportunity to replace a defective board.

Pièces

Aucune pièce nécessaire.

  1. Remove the battery and SD Card from their slots.  Leaving these in could cause the battery to ground and ruin the electronics.
    • Remove the battery and SD Card from their slots. Leaving these in could cause the battery to ground and ruin the electronics.

    • Unscrew the six screws on the casing. Two are on the bottom as pictured; two more are on each side of the camera.

    Ajouter un commentaire

  2. Pull the lanyard mount off of the camera using a spudger or your fingers.
    • Pull the lanyard mount off of the camera using a spudger or your fingers.

    Ajouter un commentaire

    • Find the line that separates the casing into its two halves. Hold each half seperately, and gently pull apart.

    • Note that there is a small metal clip holding the two halves together. It might help to press down on the back half (indicated) while pulling upward slightly on the front half.

    Ajouter un commentaire

    • Take hold of the inside of the camera, and gently pull away from the back casing.

    Ajouter un commentaire

    • Remove the square, clear, rubber protector from the front of the logic board. This is not necessary to remove, but can easily fall off and get lost during later steps.

    Ajouter un commentaire

    • When you reassemble the camera, make sure the switch on the casing (pictured left) matches the position of the switch on the camera internals.

    • The black viewfinder padding (pictured right) can easily fall off the casing. Make sure you don't lose it when moving around parts.

    Ajouter un commentaire

    • Remove the LCD cable by gently prying the hinge open with a spudger or your finger. The cable should easily slide out.

    Ajouter un commentaire

    • Lift up the metallic-colored clip with the spudger to remove the shutter panel.

    Ajouter un commentaire

    • Remove the shutter panel with the spudger, now that the clip is released.

    Ajouter un commentaire

    • Use the spudger or your finger to release the orange ribbon from the logic board.

    Ajouter un commentaire

    • Pull the ribbon out of the socket using the spudger or your finger.

    • Disconnect the two other ribbons from the logic board in the same fashion.

    Ajouter un commentaire

    • Lift up the large green flap by using the spudger to pry up top right yellow edge.

    Ajouter un commentaire

    • Pull the flap back with the spudger so that the logic board is exposed.

    Ajouter un commentaire

    • Use the screwdriver to remove the three screws on the logic board. Take note that the bottom right screw is shorter than the other two.

    Ajouter un commentaire

    • Use the spudger to carefully remove the logic board from behind.

    Ajouter un commentaire

    • Remove the detached logic board from the camera.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Chris Wren

Membre depuis le 11/04/2010

51 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 25-85, Amido Spring 2010 Membre de l'équipe Cal Poly, Team 25-85, Amido Spring 2010

CPSU-AMIDO-S10S25G85

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,918