Introduction

This guide shows how to replace the cooling fan on the Selphy CP720. This is done to fix overheating problems caused by a faulty fan.

Pièces

Aucune pièce nécessaire.

  1. Remove the four 8mm Phillips #1 screws from the bottom of the printer.
    • Remove the four 8mm Phillips #1 screws from the bottom of the printer.

  2. Gently lift the top half of the printer off its base
    • Gently lift the top half of the printer off its base

    • A data ribbon attaches the two halves, so don't pull hard and keep the two halves close together.

    • Remove the side panel by lifting it out.

    • Unplug the fan from the circuit board by gently pulling on the wire connector at the base of the port.

    • Do not tug on the wires. Slowly increasing force as you pull is the best way to detach the wires.

    • Unscrew the two 8mm Phillips #1 screws from the fan.

    • Remove the fan from the panel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Peter Ely

Membre depuis le 26/09/2018

785 Réputation

5 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 44