Aller au contenu principal

Introduction

If your battery is dead or just isn't properly holding a charge, follow this guide.

Pièces

Aucune pièce spécifiée.

  1. First, disassemble the device, taking off the bottom panel. See the disassembly guide for further directions. First, disassemble the device, taking off the bottom panel. See the disassembly guide for further directions.
    • First, disassemble the device, taking off the bottom panel. See the disassembly guide for further directions.

  2. Using the metal spudger, carefully slide it under the black rubber bottom to remove it. Using a Phillips J000 head screw driver, unscrew the 4mm screws placed on the outer corners of the metal plate. Again, take the metal spudger, placing it under the metal plate to take it off.
    • Using the metal spudger, carefully slide it under the black rubber bottom to remove it.

    • Using a Phillips J000 head screw driver, unscrew the 4mm screws placed on the outer corners of the metal plate.

    • Again, take the metal spudger, placing it under the metal plate to take it off.

  3. Once the metal plate is off, inspect the inside of the device to be sure the battery is plugged in and there's nothing blocking it. Battery malfunction is often caused by internal components that are dirty. Be sure the battery clip is plugged in properly and then reassemble device. Hold the power button and start the device up. Battery malfunction is often caused by internal components that are dirty. Be sure the battery clip is plugged in properly and then reassemble device. Hold the power button and start the device up.
    • Once the metal plate is off, inspect the inside of the device to be sure the battery is plugged in and there's nothing blocking it.

    • Battery malfunction is often caused by internal components that are dirty. Be sure the battery clip is plugged in properly and then reassemble device. Hold the power button and start the device up.

  4. If the battery is still malfunctioning, carefully unplug the battery using tweezers. Gently place the tweezers on either side of the batter to slide it out of the shell.
    • If the battery is still malfunctioning, carefully unplug the battery using tweezers.

    • Gently place the tweezers on either side of the batter to slide it out of the shell.

  5. To replace the battery, simply insert a new one into the same slot and then plug in the end to the correct spot. After the device is assembled, power the device on. The issue should be repaired. If the device battery is still defective, a greater issue is the cause.
    • To replace the battery, simply insert a new one into the same slot and then plug in the end to the correct spot.

    • After the device is assembled, power the device on. The issue should be repaired.

    • If the device battery is still defective, a greater issue is the cause.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brittany Abate

Membre depuis le 03/01/2016

407 Réputation

4 tutoriels rédigés

Équipe

USF Sarasota-Manatee, Team 1-1, Stewart Spring 2016 Membre de l'équipe USF Sarasota-Manatee, Team 1-1, Stewart Spring 2016

USFSM-STEWART-S16S1G1

3 membres

5 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 7

Total : 637