Menu 

Vos paramètres

Mon établi

Accédez rapidement aux tutoriels, aux pièces et aux réponses correspondant à vos appareils
Mon panier (US Store)

On dirait que votre panier est vide

Parcourez notre boutique

Dell Inspiron 1525 Central Control Cover Replacement

Rédigé par : Miroslav Djuric (et 2 autres contributeurs)
  • Commentaires : 0
  • Favoris : 9
  • Réparations terminées : 3

Difficulté

Modérée

Étapes

5

Temps nécessaire

10 minutes

Sections

2

Drapeaux

0

Introduction

Use this guide to help you replace the Central Control Cover on a Dell Inspiron 1525.

Outils

Acheter ces outils

Pièces

Aucune pièce nécessaire.

  1. Locate the battery release switch on the bottom of the laptop.

    • Locate the battery release switch on the bottom of the laptop.

    Traduire

  2. Slide the battery release switch away from the lock symbol until you hear the battery click. Slide the battery towards the back of the laptop until it comes free.

    • Slide the battery release switch away from the lock symbol until you hear the battery click.

    • Slide the battery towards the back of the laptop until it comes free.

    Traduire

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

  4. Remove the two 4.00 mm Phillips #1 screws from the battery tray.

    • Remove the two 4.00 mm Phillips #1 screws from the battery tray.

    Traduire

  5. Insert the flat end of a spudger into the slot on the right side of the central control cover and pry it up. Carefully pull the central control cover up along its edges. Do not attempt to completely remove the cover, as it is still attached via a ribbon cable.

    • Insert the flat end of a spudger into the slot on the right side of the central control cover and pry it up.

    • Carefully pull the central control cover up along its edges.

    • Do not attempt to completely remove the cover, as it is still attached via a ribbon cable.

    Traduire

  6. Peel back the silver tape securing the ribbon cable to the cover. Pull the small brown latch on the ribbon cable connector out. Disconnect the ribbon cable to completely free the central control cover.

    • Peel back the silver tape securing the ribbon cable to the cover.

    • Pull the small brown latch on the ribbon cable connector out.

    • Disconnect the ribbon cable to completely free the central control cover.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

0 commentaires

Ajouter un commentaire
Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 7

Total : 3,159