Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the spudger, create space between the speaker covers and then remove.
-
On the underside of the device, remove the rubber stand with the BeatsPill logo on it.
-
Using an ESD-safe Phillips #0 screwdriver, remove the four screws that were underneath the rubber stand.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two screws with a Phillips #0 screwdriver.
-
Slowly remove the center band and two clip rings until the adhesive separates. Sit to the side the clip rings and the center band
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the spudger to pry the device apart along its seam, starting in the middle.
-
Open the device to separate the front and back panels.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully remove the yellow, red, black, and white wires from the motherboard.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully remove the black and red NFC sensor wires.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully remove the control cables (4 black, 1 red).
-
Annulation : je n'ai pas terminé ce tutoriel.
5 autres ont terminé cette réparation.