Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

Use this guide to remove the rear cover of a DualShock 3 controller.

Pièces

Aucune pièce spécifiée.

  1. Remove the five 7.2 mm Phillips screws securing the rear cover to the controller.
    • Remove the five 7.2 mm Phillips screws securing the rear cover to the controller.

  2. SAUTEZ LA MISE À NIVEAU

    Économisez en réparant avec un kit tout-en-un.

    Fix Kits pour iPhone

    SAUTEZ LA MISE À NIVEAU

    Économisez en réparant avec un kit tout-en-un.

    Fix Kits pour iPhone
  3. Press on the rear cover between the analog sticks and slightly lift the lower edge of it away from the rest of the controller.
    • Press on the rear cover between the analog sticks and slightly lift the lower edge of it away from the rest of the controller.

    Es ist nicht ganz eindeutig das zwischen den beiden Analog-Sticks gedrückt werden muss. Der gelbe Punkt fällt kaum auf. Ein Bild mit Daumen an dieser Stelle wäre gut oder soooo…

    Tom - Réponse

  4. Push the rear cover slightly toward the top edge of the controller to clear the front edge of the #2 triggers. Pull the rear cover away from the rest of the controller, being careful not to pop off the #2 triggers.
    • Push the rear cover slightly toward the top edge of the controller to clear the front edge of the #2 triggers.

    • Pull the rear cover away from the rest of the controller, being careful not to pop off the #2 triggers.

    • If you happen to accidentally pop off the trigger buttons, we have a trigger button guide to reattach them.

    the "trigger button guide" link links back to this page :o

    Alexander McMahon - Réponse

    I accidentally popped a trigger off, and both L1 and R1, because I skimmed and didn't read this step. Fortunately it's not hard. The tricky part with the triggers is that there's a little spring on them. You have to press the side of the spring that's pointing away from the trigger against the sloped surface of the controller (look at the other trigger for reference, if you only popped one off). Then you just slide the trigger on until the "handlebar" bits near the center click into place.

    briancaraher - Réponse

    The reset button – a small mostly-rectangular rubberized piece – fell out as I removed the rear cover. It covers the hole near the middle screw and has a post that presses SW1 on the motherboard.

    Fletcher Stern - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

20 autre(s) ont terminé cette réparation.

i have a different dualshock 3 than yours. mine is built in a different way and has a different battery

MasterKlaus Produtions (Swe0b) - Réponse

Sony did that throughout the Dualshock 3’s production as they found out what would cause them to malfunction and fixed the issue. It should be alright as long as you are able to replace the battery when needed.

Aiodensghost -

iran:

نحوهی تعویض طلق دسته پلی سه هم بذارین. لطفان

مجید محمدی - Réponse

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 1

7 derniers jours : 6

30 derniers jours : 46

Total : 20,682