Introduction

Use this repair guide when debris needs to be cleared from the On/Off switch or it needs to be replaced.

Pièces

Aucune pièce nécessaire.

Take the battery cover off by releasing the locking tab and hinging the cover away.
  • Take the battery cover off by releasing the locking tab and hinging the cover away.

Ajouter un commentaire

Remove the six back panel screws using a Tri-wing Screwdriver.
  • Remove the six back panel screws using a Tri-wing Screwdriver.

Ajouter un commentaire

  • Remove bottom back panel screw with a Phillips #1 screw driver.

We recommend you change the the screw head to a Phillips 1 so you don't strip the screw. (Something we experienced)

Adriano Agostino - Réponse

  • Remove the back panel by pulling away with one hand and the front secured in the other hand.

  • Removal of the back panel may cause shoulder buttons and side panels to come loose and fall off.

Ajouter un commentaire

  • Remove left and right triggers by lifting and pulling them away from the system.

  • Do the same for side panels

  • For finicky or jammed triggers only. Adjust and correct triggers and reassemble. Most jammed triggers are caused by buttons misplaced or jammed in its enclosure.

Ajouter un commentaire

  • Remove the gray On/Off Switch by pulling up and away from the unit. Replace with another switch if necessary.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Adam

Membre depuis le 20/01/2010

634 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 16-29, Maness Winter 2010 Membre de l'équipe Cal Poly, Team 16-29, Maness Winter 2010

CPSU-MANESS-W10S16G29

5 membres

26 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 23

30 derniers jours : 92

Total : 11,881