Introduction

Removing the logic board from the Garmin Nuvi 200

  1. Peel off the sticker from the bottom of the device to reveal two screws.
    • Peel off the sticker from the bottom of the device to reveal two screws.

    Ajouter un commentaire

  2. Remove two T5 Torx screws.
    • Remove two T5 Torx screws.

    Ajouter un commentaire

    • Insert a plastic opening tool in the gap between the front and rear casing.

    • Carefully work the tool around the gap, separating the two halves of the case.

      • Keep the power switch in place while removing the rear case.

    Ajouter un commentaire

    • Peel away the tape holding the ribbon cable in place.

    • Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.

    Ajouter un commentaire

    • Pull out the cable between the logic board and the speaker to disconnect them.

    Ajouter un commentaire

    • Remove the three screws from the logic board using the #00 Phillips screwdriver.

    • Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.

    Ajouter un commentaire

    • Detach the logic board form the battery by pulling out the cable.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Anjelica

Membre depuis le 11/04/2010

504 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 25-90, Amido Spring 2010 Membre de l'équipe Cal Poly, Team 25-90, Amido Spring 2010

CPSU-AMIDO-S10S25G90

4 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 14

Total : 9,607