Introduction

The panel is what holds the screen in place. Before removing the panel make sure the printer is unplugged.

Pièces

Aucune pièce nécessaire.

  1. Lift up printer screen.
    • Lift up printer screen.

  2. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  3. Use the Metal Spudger from the IFIXIT Toolkit to pry the left corner of the front panel. Slowly pry the front panel by sliding the Metal Spudger along the border of the front panel. Slowly pry the front panel by sliding the Metal Spudger along the border of the front panel.
    • Use the Metal Spudger from the IFIXIT Toolkit to pry the left corner of the front panel.

    • Slowly pry the front panel by sliding the Metal Spudger along the border of the front panel.

  4. Remove the front panel by lifting each corner up. Replace the front panel.
    • Remove the front panel by lifting each corner up.

    • Replace the front panel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Elizabeth Surface

Membre depuis le 26/08/2015

1 386 Réputation

9 tutoriels rédigés

Équipe

USF Tampa, Team 4-6, Meier Fall 2015 Membre de l'équipe USF Tampa, Team 4-6, Meier Fall 2015

USFT-MEIER-F15S4G6

4 membres

9 tutoriels rédigés

My HP Envy 5530 had a screw hidden beneath the label on the right side of the front panel. I used a knife to lift the label to access the screw.

rndymike - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 19

Total : 292