Aller au contenu principal

Introduction

This guide will show how to replace the display on the HP Stream 13-c010nr. If your screen is cracked or damaged, you can follow this guide to repair it.

Pièces

Aucune pièce spécifiée.

  1. HP Stream 13-c010nr Display Replacement, HP Stream 13-c010nr Disassembly: étape 1, image 1 de 1
    • Remove the five rubber feet from the bottom of the laptop with a plastic opening tool.

  2. HP Stream 13-c010nr Display Replacement: étape 2, image 1 de 2 HP Stream 13-c010nr Display Replacement: étape 2, image 2 de 2
    • Remove the thirteen 5mm Phillips #0 screws from the bottom case.

  3. HP Stream 13-c010nr Display Replacement: étape 3, image 1 de 2 HP Stream 13-c010nr Display Replacement: étape 3, image 2 de 2
    • Flip the laptop over and open it up.

    • Wedge a plastic opening tool between the keyboard and bottom case, pry upwards to separate the two pieces.

    • Lift up the keyboard.

    • Ribbon cables still connect the two pieces.

  4. HP Stream 13-c010nr Display Replacement: étape 4, image 1 de 1
    • Use a spudger to flip up the retaining flaps on the keyboard ribbon cable ZIF sockets.

    • Pull up the ribbon cables from their sockets.

  5. HP Stream 13-c010nr Display Replacement, Display: étape 5, image 1 de 1
    • Remove the screw covers from the bottom corner edges of the screen.

  6. HP Stream 13-c010nr Display Replacement: étape 6, image 1 de 2 HP Stream 13-c010nr Display Replacement: étape 6, image 2 de 2
    • Remove the two 5mm Phillips #0 screws from the screen bezel.

  7. HP Stream 13-c010nr Display Replacement: étape 7, image 1 de 2 HP Stream 13-c010nr Display Replacement: étape 7, image 2 de 2
    • Wedge the plastic opening tool between the frame of the screen and the casing of the laptop.

    • Pry upwards on the plastic opening tool to separate the bezel from the display.

  8. HP Stream 13-c010nr Display Replacement: étape 8, image 1 de 1
    • Remove the four 3mm Phillips #0 screws from the screen.

  9. HP Stream 13-c010nr Display Replacement: étape 9, image 1 de 1
    • Use a spudger to flip up the retaining flap on the screen ribbon cable ZIF socket.

    • Pull the ribbon cable out of the ZIF socket.

    • Remove the screen.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Keegan Lapham

Membre depuis le 22/02/2018

731 Réputation

6 tutoriels rédigés

Équipe

USF Tampa, Team S1-G3, Cagle Spring 2018 Membre de l'équipe USF Tampa, Team S1-G3, Cagle Spring 2018

USFT-CAGLE-S18S1G3

4 membres

12 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 5

Total : 594