Introduction
Ceci est un tutoriel pour une manette Sony DualShock 4 PlayStation 4 et peut être utilisé sur les manettes d’autres entreprises (Scuf ou Custom Controllers).
Cette procédure permet de réparer un bouton R3 ou L3 sur une manette, qui ne fonctionne pas correctement ou qui présente des problèmes.
Faites attention pendant toute cette opération, car ce sont des pièces très petites et fragiles. Faites très attention aux étapes 1 et 2 pour ne pas endommager les nappes et fils qui relient la manette et la batterie, ainsi que lors du remontage.
Ce dont vous avez besoin
-
-
Retirer les quatre vis à l’arrière de la manette à l’aide d’un tournevis cruciforme Phillips #0.
-
Séparer l’avant et l’arrière de la manette.
-
-
Annulation : je n'ai pas terminé ce tutoriel.
43 autres ont terminé cette réparation.
Merci à ces traducteurs :
100%
Ces traducteurs nous aident réparer le monde ! Vous voulez contribuer ?
Commencez à traduire ›
5 commentaires
Thank you for this!! So many great pictures!! :D
The drift for me also prevented or interrupted movement with the left analog stick. Menus would continue to scroll after i scrolled them or wouldn’t move my character on screen.
Nach Wechsel der Potis hatte mein Controller Drift an beiden Achsen. Das liegt daran, dass die Potis nicht 100% mit denen der Werkskalibrierten übereinstimmen. Eine nachträgliche Kalibrierung ist leider nicht so einfach möglich, da die Korrekturdaten im EEPROM des Controllers gespeichert sind. Deshalb habe ich parallel zu den Potis je einen 2MOhm Poti gelötet, mit denen der Spannungsoffset kompensiert werden kann. Ergebnis: Keine Drift mehr. Die Controller arbeiten wieder einwandfrei.
Great walkthrough and high-res images makes the job a lot smoother. Only remark I have are three things: 1) There are four clips that are hard to see on the images, and aren’t detailed; they are on the top right and left, under the “SHARE” and “OPTIONS” buttons, as well as the two clips on either side of the docking port. These easily break, although I avoided that. 2) The sensor housing have very fragile clips which easily break after a repair or two. DO NOT USE FORCE ON THESE! If you’re in doubt, just try and blow some air into them. Some remaining dirt is better than a broken stick. I also avoided this thanks to a comment on the step, but I’ve heard many has broken their sensors doing this. 3) The USB connector isn’t labeled as a pull-out connector. This isn’t much of an issue, but in sub-par lit environments, it looks like a clip connector. Have some friends ruining their USB ports due to ripping the connector off the PCB, thinking it’s a clip connector.
tidak membantu sama sekali seperti padi yang terbanjiri dan tidak bisa di proses untuk menjadi nasi lalu di nikmati