Pièces

Aucune pièce nécessaire.

The Roomba Battery is the large yellow block under the Roomba's front bumper.
  • The Roomba Battery is the large yellow block under the Roomba's front bumper.

Ajouter un commentaire

Remove the battery by pressing the two side tabs, as demonstrated.
  • Remove the battery by pressing the two side tabs, as demonstrated.

  • Gently lift the battery up and out of the device.

Ajouter un commentaire

  • Obtain a replacement battery cell from the manufacturer. Simply drop the new battery into place.

Ajouter un commentaire

  • Begin by removing the rear particle bin.

Ajouter un commentaire

  • Choose either of the two wheels on the side of the Roomba and identify the three screws located on the hubcap of the wheel.

Ajouter un commentaire

  • Using a Phillips Head screwdriver, remove all three screws on the side of the hubcap of the wheel.

There are actually 4 screws holding the hubcap on. To get to the 4th screw, you need to loosen the top cover by removing all its screws. Note different lengths of screws.

Albert Jeans - Réponse

yes found that out during this operation

MaryAnne - Réponse

  • Gently slide the hubcap up and out of the wheel well of the Roomba.

I have a fourth screw well up into the body on the hub cover. ~2.5cm into the body from the round hub outer circle.

Ben Carr - Réponse

  • Mind the wires attached to the optical encoder located in the hubcap.

Ajouter un commentaire

  • Using compressed air, thoroughly clean the optical encoder until satisfied.

Ajouter un commentaire

  • With a screw driver, gently remove the drive belt from the gear.

Ajouter un commentaire

  • Carefully slide the gear out of the gear shaft of the wheel.

Ajouter un commentaire

  • Thoroughly clean the exposed area of the wheel using either compressed air or a moist cotton swab. Be mindful of the exposed inner drive shaft when cleaning the wheel area to prevent any preexisting dust from entering the drive shaft.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Christian

Membre depuis le 06/10/2010

263 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 20-7, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 20-7, Maness Fall 2010

CPSU-MANESS-F10S20G7

6 membres

7 tutoriels rédigés

Thanks for your advice. I cleaned the sensors on the wheels and still the unit was having a circular dance. From another site mentioning another model there could be a problem with the sensors behind the front bumper bar and yes that was the problem. They needed blowing out with a strong air gun. Now after extensive cleaning my Roomba is running like a dream :-)

photofil - Réponse

My problem as well with my Roomba scheduler. The black and white front wheel housing was packed with rug fiber. Cleaned it out and all is well.

Also have a roomba discovery. It has a different front wheel with out any apparent sensor.

Will Long - Réponse

I have a roomba4100 it will turn on it will try to go but will stop after 1second don't know what's wrong could it be the belt

Rodney - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 23

30 derniers jours : 96

Total : 10,928