Jawbone Big Jambox Battery Replacement

Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.

Ce dont vous avez besoin

Cette étape n’est pas traduite. Aidez à la traduire

Remove both end caps by putting a plastic opening tool in the center of the seam. Work around the edges to pry the end caps off completely.
Due to interior clips holding the end caps in place, use caution when applying force.

Cette étape n’est pas traduite. Aidez à la traduire

Turn the Jambox upside down. Peel the indicated rubber tabs off, using a plastic opening tool if necessary.
You may want to only take the tabs half way off to avoid re-gluing when reassembling.
Remove the three T6, 7.0 mm screws under each rubber tab.
Because the screws are a different length, set the screws aside.

Cette étape n’est pas traduite. Aidez à la traduire

With the Jawbone logo facing towards you and with correct orientation, place the Jambox with the left end cap facing upward.
Unscrew indicated T6 9.7 mm screws.
Gently loosen the tabs from their anchor points so the bottom may be removed.
Flip the Jambox so the other end cap is facing up. The USB cable is on this side (metal grounding clip, indicated in orange). Repeat the above two steps.

Cette étape n’est pas traduite. Aidez à la traduire

Pry up the bottom panel by lifting from the device.
Pull the bottom up. This may take a bit of force as the bottom is glued to device.
Once removed, the battery will now be visible.

Cette étape n’est pas traduite. Aidez à la traduire

Before unscrewing, take a picture of the top view. That way, when you're reassembling the device, you'll know the orientation of the metal grounding plates.
Unscrew the eight indicated T6 9.8 mm screws. Remove metal grounding plates.

Cette étape n’est pas traduite. Aidez à la traduire

Once all eight screws are removed, pry the sides of the Jambox to lift the body from it's shell.

Cette étape n’est pas traduite. Aidez à la traduire

With the battery facing forward, remove the three indicated T6 9.5 mm screws.
Once the screws are removed, lift up the small plastic plate, revealing the auxiliary board underneath.

Cette étape n’est pas traduite. Aidez à la traduire

Cette étape n’est pas traduite. Aidez à la traduire

Pull on the red and black cables under the auxiliary board to disconnect the battery.

Cette étape n’est pas traduite. Aidez à la traduire

The battery is connected to the Jambox with double-sided sticky tape. Use your finger to pry out the battery.
Place a new battery in the old battery’s place. Reverse these steps to connect the new battery.
When plugging in the new battery, ensure the red and black wires are separated around pegs so that they are not pinched when the auxiliary board is replaced.