Introduction
This is a simple repair of adding a two-hole button onto a pair of jeans. This repair requires a needle, thread, fabric scissors, and a fabric marker. After following the steps in this guide, a two-hole button should be firmly attached to a pair of jeans. Keep in mind that the needle being used in sharp and is hard to spot if dropped.
Is a two-hole button just not looking how you’d like? Here is a link to re-attach a four-hole button! Coudre un bouton
Ce dont vous avez besoin
-
-
-
Find a thread color that matches the fabric you are sewing the button on to.
Demander à FixBot
-
-
-
Loop the thread through the eye of the needle.
-
Tie a small knot around the eye of the needle with the thread.
-
-
-
Thread the needle through the fabric from the inside out.
-
Tie a knot at the end of the thread after pulling most of it through the fabric.
-
-
-
-
Sew the thread in a small 'x' where you would like to place the button.
-
-
-
Place the button over the small stitched 'x' or fabric marker spot.
-
Thread the needle through the left hole of the button from the inside out.
-
Pull the needle and thread all the way through the fabric.
-
-
-
Cross the needle over to the right hole of the button.
-
Thread the needle all the way through the fabric.
-
-
-
Repeat Steps 6-7 four to five times, until you have a secure button.
-
-
-
Create a thread shank on the inside of the fabric by looping the thread around a stitch.
-
Pull the thread all the way through the hole until it is tight.
-
Tie a knot after the final stitch to secure the stitches.
-
-
After cutting the remaining thread, your button stays on your jeans.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
Équipe
Grand Valley State University, Team S1-G11, DeVasto Winter 2021 Membre de l'équipe Grand Valley State University, Team S1-G11, DeVasto Winter 2021
GVSU-DEVASTO-W21S1G11
1 membre
2 tutoriels rédigés
