Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Éteignez votre Mac mini, déconnectez tous les câbles et retournez-le.
-
Insérez la spatule Jimmy dans la jointure entre l'aluminium du couvercle supérieur e de la partie inférieure en plastique.
-
La spatule doit s'enfoncer d'environ 9 mm.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Keep working around the perimeter, freeing the clips along the final edge.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Grasp the Airport antenna board and lift it off of the two plastic posts holding it in place. You may need to push back the black plastic tab jutting through the lower left corner of the board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the yellow tape securing the power button cable to the black plastic framework.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the three black Phillips screws securing the plastic framework to the logic board and lower case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Grasp the optical drive and mass storage unit in one hand and lift up enough so that you can see beneath it.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
With your free hand, pull the Bluetooth cable up from Bluetooth board and unplug the Airport antenna cable from the right of the Airport card. Caution: both of these connections are very small. When re-assembling unit after repair, you may want to remove the two screws holding the airport card to the assembly and lift the card up and out to re-attach the cables.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Flip the mass storage assembly over so that the fan faces up.
-
Remove the three long, black Phillips screws from the corners of the fan. These screws are strongly threaded, and will offer significant resistance.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the fan up and deroute its cable from the plastic framework and the bottom of the hard drive, removing tape as necessary.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the fan connector from the interface board.
-
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.