Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Éteignez votre Mac mini, déconnectez tous les câbles et retournez-le.
-
Insérez la spatule Jimmy dans la jointure entre l'aluminium du couvercle supérieur e de la partie inférieure en plastique.
-
La spatule doit s'enfoncer d'environ 9 mm.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Keep working around the perimeter, freeing the clips along the final edge.
-
-
-
Nous allons d'abord retirer l'antenne AirPort, située dans le coin inférieur gauche de cette image.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pry the three antenna connectors off the AirPort/Bluetooth combo card.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up off the combo card.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the three silver Phillips screws securing the combo card to the logic board.
-
Lift the combo card out of your mini.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pry the power button cable connector up off the logic board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pry the sleep light cable connector up off the logic board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the single T10 Torx lug next to the RAM sockets on the logic board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a spudger to lift the free end of the logic board off the bottom housing near the PRAM battery.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
While slightly lifting the free end of the board pull it away from the port side of the mini, minding any edges that may get caught.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the single Phillips screw between the headphone and microphone jacks on the audio board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the audio board by its free edge and pull it away from the port side of the mini.
-
Annulation : je n'ai pas terminé ce tutoriel.
3 autres ont terminé cette réparation.