Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Ôtez les dix vis suivantes, qui fixent le boîtier inférieur au boîtier supérieur :
-
Deux vis Pentalobe P5 de 2,3 mm
-
Huit vis Pentalobe P5 de 3,0 mm
-
-
-
Enlevez doucement la protection en caoutchouc du ventilateur qui se trouve au bord du dissipateur thermique.
-
-
-
-
Utilisez la pointe d'un spudger pour pousser de chaque côté du connecteur de la nappe de la caméra iSight pour le faire sortir de sa prise sur la carte mère.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Insert the tip of a spudger under each of the antenna cables near their connectors and pry up to disconnect them from the AirPort board.
-
Connect the long-sleeved cable to the center socket.
-
The short-sleeved cable connects next to the screw.
-
The remaining cable has no sleeve, and connects in the last empty socket, next to the fan.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two 2.1 mm T5 Torx screws securing the I/O board cable bracket.
-
Remove the I/O board cable bracket.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pop the I/O board connector straight up off its socket on the I/O board.
-
Push the I/O board cable up to bend it out of the way.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the tip of a spudger to push on either side of the I/O board connector to walk it out of its socket on the logic board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the following screws securing the I/O board to the upper case:
-
One 3.5 mm T8 Torx standoff screw
-
One 3.5 mm T5 Torx screw
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the I/O board cable end of the I/O board and pull toward the logic board to free the ports from the upper case.
-
Remove the I/O board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the single 2.7 mm T5 Torx screw securing the AirPort board to the I/O board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the free end of the AirPort board up slightly and pull it straight out of its socket on the I/O board.
-
Annulation : je n'ai pas terminé ce tutoriel.
20 autres ont terminé cette réparation.
Un commentaire
Thank you! My Macbook was not starting anymore and I saw that it will boot without the IO board. I got a new part, exchanged it and it is now working flawlessly.