Il est possible que cette traduction ne reflète pas les dernières mises à jour du tutoriel source. Aidez à mettre à jour la traduction ou bien consultez le tutoriel source.
Introduction
Remplacer la batterie défectueuse ou hors service en suivant ce tutoriel de réparation étape par étape. La batterie doit également être retirée par mesure de sécurité avant d'effectuer toute autre réparation sur cet appareil.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using a plastic opening tool, remove the thin plastic cover from back of the tablet by prying up from its small tab.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the five 2mm screws on the back of the device using a PH00 screwdriver.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Pry the device apart by inserting a plastic opening tool in the seam between the plastic backing and display assembly. Use the tool to unclip the plastic tabs in between the backing and the display.
-
Pull the the plastic backing off the display assembly using your hands.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Detach the three connector ribbons passing over the battery using the plastic opening tool.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the twelve 2mm screws around the perimeter of the battery with a PH00 screwdriver.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the battery by lifting it upward and pulling it away from the connector.
-
Pour remonter votre appareil, suivez ces instructions en sens inverse.
Pour remonter votre appareil, suivez ces instructions en sens inverse.
Annulation : je n'ai pas terminé ce tutoriel.
63 autres ont terminé cette réparation.
Merci à ces traducteurs :
40%
Ces traducteurs nous aident réparer le monde ! Vous voulez contribuer ?
Commencez à traduire ›
20 commentaires
that worked! watch connectors,though!
I am not never before doing something like this before, but now i do this battery replacement and it worked very well. Maybe there could be more text describing steps 4 and 6 those were parts were me as complete novice had most difficult to understand at first. Step 4 you should say that you need to open that small lever-thing what locks ribboncables in its place (picture here is accurate, but i did not understand it at first). And step 6 disconnecting actual battery cable were more simple than i first thought, just lifting it upwards and then its basically free already just pull it away. Same connecting new battery cable back is same kind simple, just push it back there but better to do it first time right since that connector loosens easily i think.
The back cover is one tough motherFer. The hardest is get to the pins behind the both speakers and in the curved corners. But the overall design is so cool