Aller au contenu principal

Introduction

Follow these steps to disassemble the plastic casing of the RIDGID R84015 X2 power drill.

  1. Remove the backplate. Using a Torx T20 screwdriver, remove the four screws attaching the back plate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

  2. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

  3. Remove the gear casing from the body. Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.
    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

  4. Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now

    Fix Kits pour batterie de MacBook

    À partir de $69.99

    Buy Now
  5. With your drill taken apart, move your attention to the trigger and forward reverse switch.
    • With your drill taken apart, move your attention to the trigger and forward reverse switch.

  6. Check to see that the forward reverse switch isn't broken.
    • Check to see that the forward reverse switch isn't broken.

    • NOTE: small tab on trigger fits into groove on forward reverse switch

  7. With the battery attached, check that the wires work when the trigger is pulled.
    • With the battery attached, check that the wires work when the trigger is pulled.

    • Put multimeter wires here.

    • If wires work and drill doesn't, the problem is with the motor.

  8. Make sure plastic is not broken and switch is not stuck.
    • Make sure plastic is not broken and switch is not stuck.

  9. Looks good, doesn't it?
    • Looks good, doesn't it?

Ligne d'arrivée

2 autre(s) ont terminé cette réparation.

Brian

Membre depuis le 12/04/2010

97 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 15-48, Garner Spring 2010 Membre de l'équipe Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 membres

5 tutoriels rédigés

I was able to diagnose and fix my problem with my black and decker following your instructions. TY

boxingchaos2011 - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 20

30 derniers jours : 65

Total : 10,559