Introduction

Use this guide to repair a broken scroll wheel. Be advised, the longevity of your repaired mouse will depend on the strength of the glue or epoxy used in the repair.

Slide the tab on the bottom of the mouse to release the top panel.
  • Slide the tab on the bottom of the mouse to release the top panel.

Ajouter un commentaire

Remove the top panel from the mouse.
  • Remove the top panel from the mouse.

Ajouter un commentaire

  • Remove four 7mm Phillips #1 screws.

Ajouter un commentaire

  • Use a spudger to pry the upper shell from the mouse at the cord entrance.

  • Move slowly. The upper case is connected to the mouse with delicate wires.

Ajouter un commentaire

  • Lift the scroll wheel out of the mouse.

Ajouter un commentaire

  • Wiggle the USB cord free of the mouse.

  • Resist the temptation to yank the cord free. The wires are very delicate and soldered connections are weak

Ajouter un commentaire

  • Remove one 3mm Phillips #1 screw.

  • The quantity and location of screws holding the board to the mouse depends on the manufacture date of this mouse. All screws should be easy to find.

Ajouter un commentaire

  • Push the broken axle piece out of the socket.

Ajouter un commentaire

  • Glue broken axle piece back onto the scroll wheel.

  • This repair will last only as long as your glue or epoxy holds. The axle will re-break with weak glue and heavy use. My axle survived several heavy use days, just long enough for Monoprice to send me a new mouse.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Jeff Snyder

Membre depuis le 07/02/2013

2 608 Réputation

4 tutoriels rédigés

Équipe

iFixit Membre de l'équipe iFixit

Community

107 membres

6 513 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 432