Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Placez le bas de la tablette vers vous.
-
Retirez les deux vis de 4,1 mm près du port de charge avec un tournevis Tri-Wing.
-
-
-
Retournez le clapet de retenue des connecteurs ZIF qui maintiennent les trois larges nappes.
-
Retirez avec précaution les trois nappes de leur prise sur la carte mère.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Hold down the motherboard with your finger and use a spudger to gently pry up the connection for the volume keys and power key.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the flat end of a spudger, disconnect the black flash cable connector from the motherboard.
-
Disconnect the white rear-facing camera connector.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to disconnect the orange front-facing camera connector.
-
Disconnect the blue Micro SD card/headphone jack connector from its socket on the motherboard.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using the flat end of a spudger, disconnect the orange speaker connectors for the left and right speakers.
-
Disconnect the gold antenna cable connector from its socket on the motherboard.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lifting from the bottom edge, gently remove the motherboard.
-
Annulation : je n'ai pas terminé ce tutoriel.
18 autres ont terminé cette réparation.
5 commentaires
Comment passe t'on de l'étape 6 à 7 ? (plastique gris qui fait le tour)
My 10.1 tablet switches on but the only thing showing on the screen is the “Samsung Galaxy 10.1” logo.
If the on/off button is held down for 20 seconds or so the screen goes blank for a few seconds then the logo reappears but nothing else happens. This logo only disappears when the battery is fully discharged.
After re-charging the battery the whole process is repeated
Any suggestions as to the problem
Jim
I'm having the same issue
have anyone found a solution?
What if I don't have screws on the outside of tablet?