Introduction

The battery is the power source for the device, without it the device is useless. This guide will help you replace it properly.

Make sure the device is powered off before beginning.
  • Make sure the device is powered off before beginning.

  • Using the Phillips #0 screwdriver, remove the 6.5mm long screw in the area circled.

Ajouter un commentaire

With the cover removed, unscrew all four of the 4.75mm long screws using the Phillips #0 screwdriver.
  • With the cover removed, unscrew all four of the 4.75mm long screws using the Phillips #0 screwdriver.

Ajouter un commentaire

  • Unplug the connector from the hard drive by pulling straight out.

Black bullet. Installing and setting up new hard drive?

Watis Ekthuvapranee - Réponse

  • Remove the two rubber feet with arrows by them on the back side to uncover two screws.

  • Unscrew the four silver 4.4mm long screws near the hard drive.

  • Unscrew the remaining nine black 6.5mm long screws. Then remove the back casing using a pry tool if needed.

Ajouter un commentaire

  • Use the screwdriver to remove the four 3.5mm long screws holding the battery in place. Then carefully pull the battery's connector cable out to remove the battery.

Got one black dot there.

Watis Ekthuvapranee - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brian Briggs

Membre depuis le 14/02/2018

421 Réputation

4 tutoriels rédigés

Équipe

USF Tampa, Team S6-G5, Eyestone Spring 2018 Membre de l'équipe USF Tampa, Team S6-G5, Eyestone Spring 2018

USFT-EYESTONE-S18S6G5

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 3

30 derniers jours : 21

Total : 104