Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using a small flat head screwdriver, gently turn the retaining screw at the bottom of the microphone counterclockwise until it stops or provides resistance.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Plug an XLR cable into the loose connector.
-
While holding the disconnect button down, pull on the cable to remove the connector from the body of the microphone.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Bend the wire around the contact point. Pin numbers are located on the outside of the connector.
-
Connect the red wire to Pin 3 and the blue wire to Pin 2.
-
Pin 1 should have a single piece of exposed wire connecting it to the metal plate on the top of the connector (the ground plate).
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
In one hand, hold the solder. In the other, hold your soldering iron.
-
Touch both the soldering iron and the solder to the contact point. The solder should melt and create a connection between the wire and the microphone connector.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the solder and then the soldering iron from the contact point.
-
Let the wire cool for 30 seconds or so.
-
If the wire is not completely connected repeat steps 2 through 5.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To reinstall the XLR connector, follow the Installing Shure SM58 XLR connector guide
-
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.
9 commentaires
I'm not familiar with the "pin 2 hot method." We took a working mic apart and reassembled it the way we found it, so I'm pretty that is the correct soldering configuration.
Świetna strona. Brawo.