Danger
Potentiellement dangereux
Risque de blessure si cette procédure n'est pas suivie correctement. Faites preuve de prudence et suivez tous les avertissements.
Danger
  1. Begin by placing the camera flat against a surface and remove the nine (9) black screws. Each screw is of the same length and can be used interchangeably
    • Begin by placing the camera flat against a surface and remove the nine (9) black screws. Each screw is of the same length and can be used interchangeably

      • Note: There are two (2) screws on each side, and five (5) on the bottom edge.

    Ajouter un commentaire

  2. Use a plastic opening tool to carefully pry off the front casing.
    • Use a plastic opening tool to carefully pry off the front casing.

      • Be careful to not to force the casing off. Simply move around the entire case separating where needed.

    Ajouter un commentaire

    • Flip the camera over 180 degrees and similarly pry off the rear casing.

    Ajouter un commentaire

    • Once the outer casings have been removed, the silver side trim should come loose from the camera.

    • Place the camera with the lens facing down. Use the plastic opening tool to pry off the side panel with the USB plug.

      • Note: If you wish to remove the top cover, see the LCD Display Replacement to remove the LCD screen before continuing to Step 5

    Ajouter un commentaire

  3. Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    • Place the camera with the lens facing down. Use the phillips head screwdriver to remove the silver screw in the corner near the photo capture button.

    • Flip the camera over. Use the plastic opening tool to detach the black clip near the capture button.

    • Grasp the top cover and gently remove it from the camera body.

    Ajouter un commentaire

    • Gently pry the tab holding the ribbon cable connecting the cameras control board to the camera sensor and battery housing.

    • The camera control board is now removed and can be replaced if faulty.

    Ajouter un commentaire

    • With the camera laying with the lens up, use the plastic pry tool to gently push the two gray tabs located on the edge of the camera face.

    • Flip the camera over. With the camera laying face down, grab the gray cover on the side and gently remove it.

    • Be careful not to handle the capacitor at the contacts, or you may get shocked.

    Ajouter un commentaire

    • Use the plastic pry tool to push the small round silver speaker out through the slot on the side.

    • With your hand, grab the speaker and gently remove the wires from the retaining clips.

    Ajouter un commentaire

    • With the camera laying with the lens up, use the spudger tool to grab the small square piece of rubber and gently pull it out.

      • Note: Be careful not to pull on it too hard, the wires connected to it are short and could easily be pulled out or damaged.

    Ajouter un commentaire

    • Place the camera facing with the lens down. Grab the black capacitor and gently remove the assembly from the holder.

    • Locate the ribbon cable connecting the capacitor to the top of the camera. Grasp the ribbon cable with your fingers, and gently pull outwards.

      • Note: You may need to gently wiggle the connector back and forth to work it out. Do not use much force to pull the cable out. If it is too difficult to remove, use the plastic pry tool to pull the connector by the tabs on the side.

    • Now the flash capacitor assembly is disconnected from the camera and can be removed.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sam Lewis

Membre depuis le 18/10/2013

398 Réputation

3 tutoriels rédigés

Équipe

Clemson, Team 13-4, Benson Fall 2013 Membre de l'équipe Clemson, Team 13-4, Benson Fall 2013

CLEM-BENSON-F13S13G4

3 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 71