Introduction

Replacing the lens mount requires removing any lens that is already attached then simply removing the casing of the lens mount.

Pièces

Aucune pièce nécessaire.

Hold lens and camera securely with two hands.
  • Hold lens and camera securely with two hands.

  • With the hand holding the camera, push down on the lens button. Twist the lens counterclockwise and pull out to release lens.

Ajouter un commentaire

Using your screwdriver, remove the four (3.5 mm) Phillips screws on the front face of the lens mount.
  • Using your screwdriver, remove the four (3.5 mm) Phillips screws on the front face of the lens mount.

  • Make sure to keep track of these screws and not misplace them.

Ajouter un commentaire

  • Remove the silver plate by gently pinching with your fingers.

Ajouter un commentaire

  • Now the black plate should be exposed. You can remove this again by gently pinching with your fingers and lifting up.

Ajouter un commentaire

  • Using the tweezers, grab the thin silver ring and lift up.

Ajouter un commentaire

  • The camera mount should now be barren and look like this.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Emily Trujillo

Membre depuis le 08/04/2014

1 081 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 8-9, Regan Spring 2014 Membre de l'équipe Cal Poly, Team 8-9, Regan Spring 2014

CPSU-REGAN-S14S8G9

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 10

Total : 1,784