Réparez vos affaires Communauté Boutique

Unbranded UB-15MS10 Speaker Replacement

Tutoriel Archivé
Ce tutoriel est conservé uniquement à des fins de suivis historiques. Utilisez la version actuelle du tutoriel pour effectuer votre réparation.

Introduction

This guide walks you through how to replace a broken speaker on your UnBranded Tablet.

Ce dont vous avez besoin

  1. Unbranded UB-15MS10 Speaker Replacement, Back Panel: étape 1, image 1 de 1

    • Remove the cover over the Micro SD outlet by using a plastic opening tool to pry open and push out the cover panel.

    Traduire

  2. Unbranded UB-15MS10 Speaker Replacement: étape 2, image 1 de 1

    • Remove the two 4-mm #0 screws from the inside of the Micro SD compartment.

    Traduire

  3. Unbranded UB-15MS10 Speaker Replacement: étape 3, image 1 de 2 Unbranded UB-15MS10 Speaker Replacement: étape 3, image 2 de 2

    • Insert blue guitar picks in the crease between the top and bottom panels starting on the same end as the Micro SD slot.

    • Inserting the picks directly under the Micro SD compartment was the easiest place to get started. It still requires some force.

    Traduire

  5. Unbranded UB-15MS10 Speaker Replacement: étape 4, image 1 de 1

    • Insert the black spudger between the guitar picks in order to pry open gaps between the blue guitar picks.

    • As the gaps open, slide the guitar picks along the sides to separate the panels.

    Traduire

  6. Unbranded UB-15MS10 Speaker Replacement: étape 5, image 1 de 1

    • Pry all four sides apart using the blue guitar picks and the black spudger until they can easily be pried apart by hand.

    Traduire

  7. Unbranded UB-15MS10 Speaker Replacement, Speaker: étape 6, image 1 de 1

    • Remove the yellow tape from the speaker.

    Traduire

  8. Unbranded UB-15MS10 Speaker Replacement: étape 7, image 1 de 1

    • Remove the two 4-mm #0 screws holding the speaker in place.

    • The copper-colored plastic piece covering the speaker does not need to be removed from the device, move it to the side to reach the screws.

    Traduire

  9. Unbranded UB-15MS10 Speaker Replacement: étape 8, image 1 de 1

    • Remove the silver tape covering the speaker's black and red wires.

    Traduire

  10. Unbranded UB-15MS10 Speaker Replacement: étape 9, image 1 de 1

    • Reflow the solder of the black and red wires from the circuit board by using the soldering iron.

    • For more information about using a soldering iron click here.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 7 autres contributeurs

Jordan Turk

Membre depuis le 09/21/15

331 Réputation

2 tutoriels rédigés

Badges: 10

+ 7 badges supplémentaires

Équipe

IUPUI, Team 2-1, Baechle Fall 2015 Membre de l'équipe IUPUI, Team 2-1, Baechle Fall 2015

IUPUI-BAECHLE-F15S2G1

3 membres

3 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 720