Aller au contenu principal
Archivé
Tutoriel Archivé
Ce tutoriel est conservé uniquement à des fins de suivis historiques. Utilisez la version actuelle du tutoriel pour effectuer votre réparation.
Archivé

Introduction

This guide walks you through how to replace a broken speaker on your UnBranded Tablet.

  1. Remove the cover over the Micro SD outlet by using a plastic opening tool to pry open and push out the cover panel.
    • Remove the cover over the Micro SD outlet by using a plastic opening tool to pry open and push out the cover panel.

  2. Remove the two 4-mm #0 screws from the inside of the Micro SD compartment.
    • Remove the two 4-mm #0 screws from the inside of the Micro SD compartment.

  3. Insert  blue guitar picks in the crease between the top and bottom panels starting on the same end as the Micro SD slot. Inserting the picks directly under the Micro SD compartment was the easiest place to get started.  It still requires some force.
    • Insert blue guitar picks in the crease between the top and bottom panels starting on the same end as the Micro SD slot.

    • Inserting the picks directly under the Micro SD compartment was the easiest place to get started. It still requires some force.

  4. Insert the black spudger between the guitar picks in order to pry open gaps between the blue guitar picks.
    • Insert the black spudger between the guitar picks in order to pry open gaps between the blue guitar picks.

    • As the gaps open, slide the guitar picks along the sides to separate the panels.

  5. Pry all four sides apart using the blue guitar picks and the black spudger until they can easily be pried apart by hand.
    • Pry all four sides apart using the blue guitar picks and the black spudger until they can easily be pried apart by hand.

  6. Remove the yellow tape from the speaker.
    • Remove the yellow tape from the speaker.

  7. Remove the two 4-mm #0 screws holding the speaker in place.
    • Remove the two 4-mm #0 screws holding the speaker in place.

    • The copper-colored plastic piece covering the speaker does not need to be removed from the device, move it to the side to reach the screws.

  8. Remove the silver tape covering the speaker's black and red wires.
    • Remove the silver tape covering the speaker's black and red wires.

  9. Reflow the solder of the black and red wires from the circuit board by using the soldering iron.
    • Reflow the solder of the black and red wires from the circuit board by using the soldering iron.

    • For more information about using a soldering iron click here.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jordan Turk

Membre depuis le 21/09/2015

331 Réputation

2 tutoriels rédigés

Équipe

IUPUI, Team 2-1, Baechle Fall 2015 Membre de l'équipe IUPUI, Team 2-1, Baechle Fall 2015

IUPUI-BAECHLE-F15S2G1

3 membres

3 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 668