Réparez vos affaires Communauté Boutique

Zoomer Dino Boomer Nose Sensor Replacement

Introduction

Before removing and replacing the sensor of Zoomer Dino Boomer, check the Troubleshooting Page to make sure the issue with gesture mode cannot be fixed without removing the sensor.

Ce dont vous avez besoin

  1. Zoomer Dino Boomer Nose Sensor Replacement, Nose Sensor: étape 1, image 1 de 2 Zoomer Dino Boomer Nose Sensor Replacement, Nose Sensor: étape 1, image 2 de 2

    • Unscrew the two 7.5 mm Phillips #0 screws at the base of the neck.

    • Remove the two 7.2 mm Phillips #0 screws above these at the base of the mouth.

    Modifier

  2. Zoomer Dino Boomer Nose Sensor Replacement: étape 2, image 1 de 2 Zoomer Dino Boomer Nose Sensor Replacement: étape 2, image 2 de 2

    • Use the spudger to pry Zoomer Dino Boomer's lower jaw from its mouth.

    Modifier

  4. Zoomer Dino Boomer Nose Sensor Replacement: étape 3, image 1 de 2 Zoomer Dino Boomer Nose Sensor Replacement: étape 3, image 2 de 2

    • Remove the roof of Zoomer Dino Boomer's mouth by unscrewing the 7.5 mm Phillips #0 screw.

    Modifier

  5. Zoomer Dino Boomer Nose Sensor Replacement: étape 4, image 1 de 2 Zoomer Dino Boomer Nose Sensor Replacement: étape 4, image 2 de 2

    • Carefully push the sensors out of the nose socket with your fingers.

    Modifier

  6. Zoomer Dino Boomer Nose Sensor Replacement: étape 5, image 1 de 3 Zoomer Dino Boomer Nose Sensor Replacement: étape 5, image 2 de 3 Zoomer Dino Boomer Nose Sensor Replacement: étape 5, image 3 de 3

    • Use a soldering iron to remove the wires from the sensor chip by melting the metal joints on the chip.

    • Use the tweezers to remove the wires as you are soldering them.

    • Do not touch any parts of Zoomer Dino Boomer or yourself when using the soldering iron. The soldering iron will be very hot.

    • When reassembling, extra solder may be required to reconnect the wires with the circuit board.

    Modifier

  7. Zoomer Dino Boomer Nose Sensor Replacement: étape 6, image 1 de 1

    • Remove and replace the nose sensor.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 2 autres contributeurs

Lauren Mannix

Membre depuis le 08/29/15

398 Réputation

3 tutoriels rédigés

Badges: 11

+ 8 badges supplémentaires

Équipe

USF Tampa, Team 16-1, Wollert Fall 2015 Membre de l'équipe USF Tampa, Team 16-1, Wollert Fall 2015

USFT-WOLLERT-F15S16G1

3 membres

10 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 4

Total : 1,329