Introduction

Replace the dock connector on your iHome iP11, so you can play music and charge your battery once again. For help troubleshooting click the link to our troubleshooting page iHome IH11 Troubleshooting.

Remove the two 9mm screws that hold on the dock connector with a Phillips #1 Screwdriver.
  • Remove the two 9mm screws that hold on the dock connector with a Phillips #1 Screwdriver.

Ajouter un commentaire

Pop the dock connector out of the iHome and gently pull the white plastic plug connected to the dock connector apart.
  • Pop the dock connector out of the iHome and gently pull the white plastic plug connected to the dock connector apart.

  • Remove the four 7.0mm screws with a Phillips #1 screwdriver.

Ajouter un commentaire

  • Remove both of the black plastic pieces. They should easily slide off of the two guide holes in the circuit board.

  • The dock connector should now be exposed. You can now simply put your new dock connector in the old one's place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Nick Knowles

Membre depuis le 19/04/2013

9 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 14-9, Maness Spring 2013 Membre de l'équipe Cal Poly, Team 14-9, Maness Spring 2013

CPSU-MANESS-S13S14G9

5 membres

5 tutoriels rédigés

Where can I buy a replacement dock connector?

A Ross - Réponse

Likewise, this guide isn't much good if it uses parts that are unavailable.

CJ Shumate - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 2,187