Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

Prereq only for removing the logic board, fan and power supply are out.

Pièces

Aucune pièce spécifiée.

  1. Lift the hard drive from the edge nearest the logic board and pull it slightly out of its recess. The hard drive is attached by a single SATA power/data cable—do not attempt to fully remove it from the iMac yet. The hard drive is attached by a single SATA power/data cable—do not attempt to fully remove it from the iMac yet.
    • Lift the hard drive from the edge nearest the logic board and pull it slightly out of its recess.

    • The hard drive is attached by a single SATA power/data cable—do not attempt to fully remove it from the iMac yet.

  2. Use a spudger to disconnect the single SATA power and data combo cable by gently prying its large plastic connector away from the hard drive. Use a spudger to disconnect the single SATA power and data combo cable by gently prying its large plastic connector away from the hard drive.
    • Use a spudger to disconnect the single SATA power and data combo cable by gently prying its large plastic connector away from the hard drive.

  3. Remove the hard drive assembly from the iMac.
    • Remove the hard drive assembly from the iMac.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 101