Aller au contenu principal

Reemplazo de interruptor de lavadora (reparación de tarjeta de control)

Anglais
Espagnol

Traduction de l’étape 7

Étape 7
Washing Machine Switch Replacement (fix control board), Testing switches: étape 0, image 1 de 2 Washing Machine Switch Replacement (fix control board), Testing switches: étape 0, image 2 de 2
Testing switches
  • The two arrows on the right show the clips that were holding the right side in place.

  • At this point you could use a ohm meter to test some of the switches. The resistance when the switch is pressed should be a few ohms or less.

  • My switches measured between 200 ohms and 2K ohms when pressed and were likely the problem.

  • The picture with the circles show where a few of the switches are. Again, make sure the washing machine is unplugged. Put an ohm meter across the two large solder blobs in the circle and press the button. You may need someone to hold the control panel while you do this.

  • If this is too awkward you can remove the control panel and then test the switches (see the next step).

  • My meter showed about 7K ohms when not pressed. Note: The 7K ohms is from resistors on the board, not the switch. When the switch is pressed the resistance between the solder blobs should be a few ohms or less. If the resistance is much higher the switch is probably bad and should be replaced.

Las dos flechas en la derecha muestran los clips que mantienen el lado derecho en su lugar.

En este punto puedes usar un óhmetro para revisar alguno de los interruptores. La resistencia cuando el interruptor esta presionado debe ser de pocos ohms.

Mis interruptores midieron entre 200 ohms y 2K ohms cuando los presione y estos eran el problema.

La imagen con los círculos muestran donde están algunos de los interruptores. Nuevamente, asegúrate que la lavadora este desconectada. Coloca el óhmetro entre las dos gotas de soldadura en el círculo y presiona el botón. Puede que necesites a alguien que sostenga el panel de control mientras tu haces esto.

Si esto es muy incomodo puedes remover el panel de control y después revisar los interruptores (ve el siguiente paso).

Mi medidor mostro cerca de 7K ohms cuano no estaba presionado. Nota: Los 7K ohms es de la resistencia en la tarjeta, no del interruptor. Cuando el interruptor esta presionado la resistencia entre las gotas de soldadura debe ser de algunos ohms. Si la resistencia es más alta el interruptor posiblemente este dañado y debería ser reemplazado.

Vos contributions sont faites dans le cadre de la licence open source Creative Commons.