Mirror
BODY MIRROR POWER MIRROR CONTROL SYSTEM
PARTS LOCATION
MI
MI
SYSTEM DIAGRAM
MI
MI
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the causes of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Power mirror control system
| Symptom | Suspected area | See page |
|---|---|---|
| Mirror does not operate | ACC fuse | MI-1 |
| Mirror does not operate | Outer mirror switch assembly (for hatchback) | MI-21 |
| Mirror does not operate | Outer mirror switch assembly (for sedan) | MI-18 |
| Mirror does not operate | Outer rear view mirror assembly (for hatchback) | MI-14 |
| Mirror does not operate | Outer rear view mirror assembly (for sedan) | MI-9 |
| Mirror does not operate | Wire harness | - |
| Mirror operates abnormally | Outer mirror switch assembly (for hatchback) | MI-21 |
| Mirror operates abnormally | Outer mirror switch assembly (for sedan) | MI-18 |
| Mirror operates abnormally | Outer rear view mirror assembly (for hatchback) | MI-14 |
| Mirror operates abnormally | Outer rear view mirror assembly (for sedan) | MI-9 |
| Mirror operates abnormally | Wire harness | - |
Table Caption: This table lists potential causes for mirror malfunctions, indicating the suspected area, whether the vehicle is a hatchback or sedan, and the corresponding page number for further diagnosis. It covers issues where the mirror does not operate or operates abnormally.
BODY MIRROR INNER REAR VIEW MIRROR
COMPONENTS
REMOVAL
- REMOVE INNER REAR VIEW MIRROR ASSEMBLY
- (a) Pinch the cover, disengage the 2 claws and remove the cover.
MI
MI
- (b) Push the lever, and slide and remove the inner rear view mirror.
INSTALLATION
- INSTALL INNER REAR VIEW MIRROR ASSEMBLY (a) Slide and install the inner rear view mirror.
- (b) Engage the 2 claws and install the cover.
BODY MIRROR OUTER REAR VIEW MIRROR (for Sedan)
COMPONENTS
MI
MI
REMOVAL
HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- REMOVE CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See page ED-9)
- REMOVE FRONT ARMREST BASE UPPER PANEL (See page ED-9)
- REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (See page ED-9)
- REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY (See page ED-11)
- REMOVE OUTER REAR VIEW MIRROR
- (a) w/ Power mirror: Disconnect the connector.
- (b) Remove the 3 nuts, disengage the claw and remove the outer rear view mirror.
7. REMOVE OUTER MIRROR COVER
- (a) Apply protective tape to the lower part of the mirror body.
- (b) Press down the upper part of the mirror and tilt the mirror.
- (c) Insert a moulding remover into the 2 clip installation positions on the lower part of the mirror to disengage the 2 clips.
- (d) Remove the mirror by pulling it downward.
- (e) Disengage the 4 claws from the inside of the mirror body.
- (f) Push the upper part of the mirror cover forward to tilt it, and then disengage the claw on the lower part to remove the outer mirror cover.
INSPECTION
- INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH
- (a) Check the operation.
- (1) Apply battery voltage to the outer rear view mirror and check the operation of the outer rear view mirror.
Standard
| Measurement Condition | Mirror Assembly Operation |
|---|---|
| Battery positive (+) - Terminal 5 (MV) Battery negative (-) - Terminal 4 (COM) | Turns upward |
| Battery positive (+) - Terminal 4 (COM) Battery negative (-) - Terminal 5 (MV) | Turns downward |
| Battery positive (+) - Terminal 3 (MH) Battery negative (-) - Terminal 4 (COM) | Turns left |
| Battery positive (+) - Terminal 4 (COM) Battery negative (-) - Terminal 3 (MH) | Turns right |
Table Caption: This table details how applying a positive and negative voltage across specific terminals of a mirror assembly controls its directional movement.
If the result is not as specified, replace the outer rear view mirror.
MI
MI
2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH
- (a) Check the operation.
- (1) Apply battery voltage to the outer rear view mirror and check the operation of the outer rear view mirror.
Standard
| Measurement Condition | Mirror Assembly Operation |
|---|---|
| Battery positive (+) - Terminal 5 (MV) Battery negative (-) - Terminal 4 (COM) | Turns upward |
| Battery positive (+) - Terminal 4 (COM) Battery negative (-) - Terminal 5 (MV) | Turns downward |
| Battery positive (+) - Terminal 3 (MH) Battery negative (-) - Terminal 4 (COM) | Turns left |
| Battery positive (+) - Terminal 4 (COM) Battery negative (-) - Terminal 3 (MH) | Turns right |
Table Caption: This table outlines how applying battery voltage to different terminals of a mirror assembly controls its directional movement. Reversing the polarity between terminal pairs (5 and 4, or 3 and 4) results in opposite directional operation.
If the result is not as specified, replace the outer rear view mirror.
INSTALLATION
1. INSTALL OUTER MIRROR COVER
- (a) Engage the claw on the lower part of the mirror cover.
- (b) Engage the claw on the upper part of the mirror cover.
- (c) After installing the outer mirror cover, check that there are no gaps between the cover and the mirror body.
NOTICE:
If there is a gap between the cover and the mirror body, it may cause noise during driving.
- (d) Engage the 2 claws of the outer rear view mirror.
- (e) Engage the 2 clips and install the mirror.
2. INSTALL OUTER REAR VIEW MIRROR
- (a) Engage the claw and install the outer rear view mirror with the 3 nuts. Torque: 8.0 Nm (82 kgfcm, 71 in.*lbf)
- (b) w/ Power mirror: Connect the connector.
- INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY (See page ED-26)
- INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (See page ED-28)
- INSTALL FRONT ARMREST BASE UPPER PANEL (See page ED-28)
- INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) (See page ED-29)
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- Torque: 5.4 Nm (55 kgfcm, 48 in.*lbf)
MI
MI
BODY MIRROR OUTER REAR VIEW MIRROR (for Hatchback) COMPONENTS
REMOVAL
HINT:
- Use
Rejoignez iFixit gratuitement pour lire le document complet (22 pages)
Nous demandons de créer un compte gratuit pour nous aider à bloquer les bots et à préserver iFixit pour la communauté.
