White logo of Death after screen and battery replacement?
Replaced the screen/digitizer and the battery and now the phone just boots to the white apple logo, doesn't move from there. Can't power it off unless you open the phone back up and disconnect the battery. Tried disconnecting the battery, screen, and reconnecting with the same results.
Read that new batteries sometimes do this to phones, letting the battery completely drain then recharging usually fixes it. But I'm just looking for more insight on this problem and if anyone ran into this problem. I've replaced dozens of screens and never ran into this issue before where I can't power down or go into recovery/DFU mode with a screen/battery replacement.
Computer sees the device in device manager, but can't see it in iTunes.
Just hoping the board isn't fried, I'd be quite surprised if it was fried. I'm very good about ESD and making sure my screws are in the right places.
Now that the phone has died and is now charging, when booting, it shows coding across the screen. Stays there, then reboots. Thoughts? I'm think dead board or it needs a restore.
Cette question est-elle utile ?