Aller au contenu principal

La version cellulaire de l'iPad Air deuxième génération d'Apple. Modèle A1567.

Questions au sujet de 45 Voir tout

Backlight only no Apple logo or screen after screen replacement

I just replaced an iPad Air 2 LCD and digitizer but the display is only showing the backlight. I’m getting no Apple logo or any thing showing on the screen. I have also discovered when I push down on the longer LCD cable connected to the logic board I hear Siri chime. I can hear the click when pushing sleep wake but no matter what I do no display. I have tried reseating the cables, a hard reset as well as connecting the old damaged screen (minus the home button) but to no avail no screen.

Update: I should clarify the old damaged screen works but has lines all up and down it. But it does actually display something whereas the new screen shows absolutely nothing.

Has as anyone else experienced this?!

Répondez à cette question J'ai le même problème

Cette question est-elle utile ?

Score 1

Commentaires:

I should clarify the old broken screen works but just has lines on it. The new screen has nothing

par

Ajouter un commentaire

Batteries pour ordinateurs portables

Une réparation facile pour un gain en puissance max.

Acheter maintenant

Batteries pour ordinateurs portables

Une réparation facile pour un gain en puissance max.

Acheter maintenant

2 réponses

Réponse la plus utile

Did you isolate the battery before disconnecting and re-connecting the display assembly, as seen here in steps 29-30 of this guide?

Failure to do this exposes the LCD and or backlight circuit to short circuits. This would then be a logic board issue and the usual test would be to plug the original screen back. In this case, both your screens suffer from the same problem so you most likely have a logic board failure. Look around the connectors to see if there is a damaged or burnt component. This will require a micro-soldering repair and is not DIY.

Cette réponse est utile ?

Score 1
Ajouter un commentaire

Sometimes the tiny pins get damaged also on the connection points where the assembly plugs into the board.

Cette réponse est utile ?

Score 0
Ajouter un commentaire

Ajoutez une réponse

krazymusikchik sera éternellement reconnaissant.
Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 11

Total : 151