Réparez vos affaires Communauté Boutique

Sorti le 25 septembre 2015. Modèle A1688/A1633. La réparation de ce modèle est similaire à celle des versions précédentes et nécessite tournevis et outils pour faire levier. Disponible en GSM et CDMA / 16, 64 ou 128 Go / Argent, Or, Gris sidéral ou Or rosé.

2690 questions Voir tout

Options

Pressure spot after screen replacement?

Replaced a severely cracked screen on my friend’s iPhone 6S so I could use it temporarily while waiting for the next gen to come out. Have replaced several screens and am pretty confident at this point.

After replacement, I see a spot (~1x1/4” at the top center of the screen). This spot is only there when the phone is completely reassembled. When i turn it on before the screen is snapped back into the case the screen is fine.

Is this caused by some sort of pressure from under the screen? I’ve removed some of the padding that the connectors come with but this does not help the issue. Anyone ever experienced this before?

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

3 Réponses

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

Don’t remove the padding from the connectors, those pads/cushions/sponges are there to insure the connector stays fully seated even after a minor impact.

If you are seeing a white spot, that is indeed caused by a pressure spot. Based on where you say it is, it sounds like its caused by the earpiece/sensor flex bracket or the IC on the screen flex (see the picture here). It is probably not sitting properly within the housing. Also check the battery to insure it is inflated, the black skin around the battery should be very tight, like shrink wrap.

Image iPhone 6s Screen

Produit

iPhone 6s Screen

$59.99

Cette réponse est-elle utile ?

Oui Non
Indice 3
Ajouter un commentaire

Options

For the iPhone 6 in particular, the pressure-spot will occur if the ribbon Cable is slightly longer than the section on the frame (See Image) allows for.

Block Image

This is an issue that can occur when using an aftermarket screen. If you purchased the screen recently, I would suggest asking for a replacement as this is a manufacturing defect. This issue happens when the size of aftermarket chips, frame, and even ribbon cables are not proportioned the same as OEM screens.

Cette réponse est-elle utile ?

Oui Non
Indice 2

1 commentaire:

Thank you so much for this information, you saved my butt!!

par

Ajouter un commentaire

Options

I get this a lot on the iPhone 6s, the screen does not need to be changed out for another one. Simply that rectangle justs needs to be pushed up a little more closer to the top so that it makes clearance from touching the logic board which causes this pressure spot at the top of the screen on the middle column.

You can either push it up then quickly close it up or disconnect the screen with the battery unplugged and use scotch tape to keep it pulled up closer to the top of the screen.

See this image for reference:

Block Image

Cette réponse est-elle utile ?

Oui Non
Indice 1
Ajouter un commentaire

Ajouter une réponse

egotistdown sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 17

30 derniers jours : 33

Total : 4,011