I have accidentally separated the keyboard Zif connector on my HP 15-n230sa laptop from the main board. Didn't realise the tab was on the opposite side of the connector and stupidly prised it off the board.
Please would you mind taking a look at the pictures and tell me whether this can be rectified? Is there anyway to reseat it back on the board?
Thanks in advance!
Cette question est-elle utile ?
Rep: 479,7k
35
329
971
You are very lucky! The solder pads didn’t get damaged so it should be possible to re-solder the connector back down.
Now the tricky part! To do this right you need a re-work system which uses hot air. Your best bet is to find someone local to you with the needed tools to remount it.
Cette réponse est-elle utile ?
Rep: 1
1
go to hit shows on utube, the fellow speaks mostly indian, but if you watch he cuts plastic to fit over the end of the ribbon and a small piece for tension on the underside and heats them and then inserts them and they hold solid.
Cette réponse est-elle utile ?
Dernières 24 heures : 2
7 derniers jours : 6
30 derniers jours : 7
Total : 155
1 commentaire
I will find some who can re-solder this for me. Thank you very much for answering my question, much appreciated.
par Andrew Hawker