Réparez vos affaires Communauté Boutique

La manette Nintendo GameCube DOL-003. Sortie en novembre 2001, compatible avec la Nintendo GameCube, la Nintendo Wii, la Nintendo Wii U et la Nintendo Switch. La réparation de cet appareil est simple et ne nécessite que des outils courants.

46 questions Voir tout

Options

Would Sugru work to fill this in?

Block Image

Block Image

I have a Wii I explicitly bought to use as a Component Gamecube, due to the cost of actual Gamecube component cables. I may use it for Wii games, but I also didn’t even use the one from 2007 for games most of the time and that was a shared Wii.

The controllers work, but the grips have always been gone as long as I have owned them. I tolerate it, but now I think I’m going to use it enough to justify rebuilding the grips.

I am looking at trying white Sugru or an epoxy stick and matte spray paint to fill this in best I can and make it look flush. Either way, I will need to sand it.

Out of both of these materials, which one would be cheaper to use while still working as a filler? I don’t know what type of plastic they are (iconcepts game fury) but I know clone controllers enough to suspect ABS.

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 1
Ajouter un commentaire

1 Réponse

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

I use sugru to fill in small holes but this looks like a job for a clear epoxy plus it would be nice and smooth.

Cette réponse est-elle utile ?

Oui Non
Indice 2

4 commentaires:

Yeah - I figured it looked like an epoxy job. I decided to look into the stick type because of how small one low is - I have attached a photo with an Exacto knife as a reference point. Would have been nice to use Sugru since it doesn't need paint though.

I would need paintable epoxy because I want the controller to pass as much as I can. What I may need to do is tape it over, fill it with epoxy and sand it as needed IF I spill.

par

Look at the white epoxies, paint comes off. https://www.amazon.com/Pratley-Quickset-...

par

@mayer I have a original bumper left :-). I can make a mold, use Epoxy to form it and rebuild without messing with the controllers.

par

Remember that if you are using just standard mold making material, your result will be smaller.

par

Ajouter un commentaire

Ajouter une réponse

Nick sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 220