Réparez vos affaires Communauté Boutique

La Xbox One S, conçue par Microsoft Corporation, est sortie en août 2016. La Xbox One S est une refonte de la Xbox One.

428 questions Voir tout

Options

No Display - TV Detects a signal

Had a xbox one that was turning on, staying black screen and then turning off after 30 seconds. Opened the console and replaced the HDMI Retimer. Put console back together and it now boots and stays on, TV recognises a source however it stays a black screen. I have tried booting to recovery mode, tried a new hard drive. Tested the 2 filters behind the HDMI port and they have continuity.

Is there any other fuses or filters that could be faulty on the HDMI circuit or is it a completely different fault all-together?

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

1 Réponse

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

Usually turn off after 30 seconds indicates board problem or bad HDD.

But as you say it’s now staying on I’m leaning on either a dud replacement HDMI Chip (these are quite common depending on where you buy it from). Or the graphics chip APU has gone bad.

Cette réponse est-elle utile ?

Oui Non
Indice 2

1 commentaire:

Turns out I had missed a pin I think when replacing the retimer. I reflowed it again and it started working. Turns out the HDD was dead as well.

Strange that they both went at the same time, normally it's one or the other

par

Ajouter un commentaire

Ajouter une réponse

EvansITLtd sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 8

Total : 1,069