Réparez vos affaires Communauté Boutique

A1708 / EMC 2978 — lancé en octobre 2016, ce nouveau Macbook Pro entrée de gamme conserve les traditionnelles touches de fonction (contre la Touch Bar sur les autres modèles). Cette version est équipée d'un intel Core i5 et de deux ports Thunderbolt 3.

216 questions Voir tout

Options

I replaced the screen with a known good one and it worked for 1 boot

I'm a little confused about this one. I have a Macbook that wasn't outputting video to the screen (but works to a monitor). I took a screen from a parts machine with a bad logic board, and put it on half way (I didn't connect the battery or half of the screws, just enough to hold it in place and turn it on). When I did this, it booted up fine. So I went and put the rest of the screws in, and now it behaves like the old screen, where the backlight come on but no video.

Any ideas?

Thanks

Répondu ! Afficher la réponse J'ai le même problème

Cette question est-elle utile ?

Oui Non
Indice 0
Ajouter un commentaire

1 Réponse

Filtrer par :
Les plus utiles Les plus récentes Les plus ancien(ne)s
Solution retenue

Options

I would check the Lid sensor at this point. The Hall sensor is located on the logic board just above the USB-C sockets in the outside corner. It’s on the backside so you can’t see it without taking the logic board out

Block Image

To test things you can use a rare earth magnet sliding it across the top surface of the uppercase. To help locate the area take a steel paperclip carefully sliding it across the face of the display, you should note the magnet grabbing the paperclip. Now take note of the location using a piece of tape, then fold the display lid down to find the location on the uppercase so you can slide the magnet across.

If you have a second system give it a try there first so you get the idea.

Sadly, it only reacts when you bring the magnet to the sensor to turn the display off (Clam Shell Mode) in this case that won’t help you as the sensor is stuck in closed mode.

You could see if the sensor has a cold solder joint, otherwise this is a logic board replacement, and the display was likely OK.

Cette réponse est-elle utile ?

Oui Non
Indice 1

2 commentaires:

Thanks for this info Dan, I hadn't come across this previously.

Turns out, the Display does light up as long as it's not opened beyond 45% or so. This would be a cable issue requiring replacing the display assembly, correct?

par

@maccentric - You stated you had tried a second display. So you ended up having two bad displays then!

The angle of the display altered things then you need a third display to fix this system.

par

Ajouter un commentaire

Ajouter une réponse

maccentric sera éternellement reconnaissant.
Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 8

30 derniers jours : 10

Total : 41