Rep: 1
1
Hello,
I get a f06 code on the washer when I run a complete wash cycle. I can usually run a rinse and drain cycle. I read the f06 post and tried unplugging and replugging various connectors on the CCU and MCU. I suspect a failing part, possibly a speed or rotation sensor. Where are these sensors?
Cette question est-elle utile ?
Rep: 450,9k
11
367
1,4k
Hi @mron
There is no balance sensor in the washer. At least there's none shown in the parts list for the washer.
Intermittent problems can be hard to find so perhaps try checking the connections between the MCU and the drive motor to see if they're all OK i.e. not loose, corroded etc.
Here's the tech sheet for the washer that may also help. On p.8 it describes how to check the windings for the motor, just in case one winding is not within spec or is on the limit of what may be acceptable to the MCU.
Cette réponse est-elle utile ?
The tech sheet is very helpful! thanks
Dernières 24 heures : 0
7 derniers jours : 0
30 derniers jours : 0
Total : 38
Hi @mron,
What is the model number of the washer?
par jayeff
It's an elite quiet pack 4
par Ron Moreland
@mron
The model number would help to ensure that if parts are required that the correct part can be found.
par jayeff
110 45972400
par Ron Moreland
110 45972400
par Ron Moreland
Voir 4 commentaires en plus