Introduction

The USB port is a common issue with these devices. Our example device's USB port was completely broken off the device. The port is attached to the motherboard by two solder joints, making it easy to reattach or replace once the motherboard has been removed.

Use a plastic opening tool to pry the back panel off by inserting it in between the front and back panel.
  • Use a plastic opening tool to pry the back panel off by inserting it in between the front and back panel.

  • There are clips that need to be released on all four sides of the device.

  • When replacing the back cover insert the bottom side first ( usb and hdmi ports stick out about 2mm ) inserting them into the covers openings will allow for easier reassembly

Ajouter un commentaire

Remove the battery connector using either your fingers or a pair of tweezers.
  • Remove the battery connector using either your fingers or a pair of tweezers.

Ajouter un commentaire

  • Unscrew two 1.17x2.9mm Phillips screws from the white connector port.

  • Lift the battery connector away from the motherboard using a spudger.

Ajouter un commentaire

Ajouter un commentaire

Ajouter un commentaire

  • Remove the clipped ZIF data connector coming from underneath the motherboard.

    • Lift up the black plastic clip with a spudger.

    • Pull the connector out gently using tweezers.

  • Be careful to ensure that the black plastic clip has been lifted away from the connector ribbon before pulling on the connector. The clip should be loose and easy to wiggle. Removing the connector before it is unclipped can cause damage.

Ajouter un commentaire

  • Remove the following five screws from the motherboard.

    • Three 1.5x2.5mm Phillips screws

    • Two 1.55x2.38mm Phillips screws

Ajouter un commentaire

Ajouter un commentaire

  • Gently lift the motherboard away from the device. If there is any resistance, check the previous steps to ensure that all connections have been removed.

Ajouter un commentaire

  • Use your soldering skills to detach the USB port from the motherboard at the following two solder joints.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

13 autre(s) ont terminé cette réparation.

Nathan

Membre depuis le 12/10/2014

632 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 14-27, Maness Fall 2014 Membre de l'équipe Cal Poly, Team 14-27, Maness Fall 2014

CPSU-MANESS-F14S14G27

4 membres

6 tutoriels rédigés

excelent step by step guide not taking peoples knowledge for granted good stuff rgards pete smith.

callum Smith - Réponse

Fantastically easy to follow step by step instructions with diagrams that are superbly explained - afterall I am but a 'mere woman's!! Thankyou, I love this site. Definitely *****

Justine Franklin - Réponse

J'ai changer les batteries et j'ai une image plein de ligne,qu'est-ce qu'il se passe ?

Sylvain - Réponse

I was defeated but the USB port which has proof impossible to unsolder. I give up.. let’s just hold I have not damaged the board

Stephen Missah - Réponse

i had tge same issue, cant desolder? what to do now, its in my hand right now.

catmando1962 - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 16

30 derniers jours : 82

Total : 8,499