Introduction

Removing the front cover gives access to lens housing, and allows removal of the top cover.

Pièces

Aucune pièce nécessaire.

  1. Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.
    • Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.

    Ajouter un commentaire

  2. Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.
    • Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.

    Ajouter un commentaire

    • Remove the battery from inside the battery housing and set the cover aside.

    Ajouter un commentaire

    • Remove the two 6.4mm screws above the lens aperture using a phillips #00 screw driver.

    Ajouter un commentaire

    • Remove the 6.4mm screw from the inside of the flash bezel.

    Ajouter un commentaire

    • Flip the camera upside down and remove the 5.4mm screw below the lens bezel on the front of the camera.

    Ajouter un commentaire

    • Remove the 5.6mm screws behind the battery cover.

    Ajouter un commentaire

    • Remove two 6.4mm screws on the latch mechanism on the right side of the camera.

    Ajouter un commentaire

    • Remove the 6.4mm screw on the top of the inside edge of the battery hole.

    Ajouter un commentaire

    • Starting at the flash, carefully pull the front cover away from the camera.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mark

Membre depuis le 20/04/2011

93 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 8-9, Regan Spring 2011 Membre de l'équipe Cal Poly, Team 8-9, Regan Spring 2011

CPSU-REGAN-S11S8G9

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 2,081