Introduction

This guide will show you how to remove the front and back casing of the camera.

Pièces

Aucune pièce nécessaire.

On the bottom of the camera, use your thumb to press the rubber battery cover towards the side of the camera with the strap base. The cover will shift to extend beyond the rest of the camera.
  • On the bottom of the camera, use your thumb to press the rubber battery cover towards the side of the camera with the strap base. The cover will shift to extend beyond the rest of the camera.

Ajouter un commentaire

Hold the end of the battery cover that extends beyond the camera and lift it up.
  • Hold the end of the battery cover that extends beyond the camera and lift it up.

Ajouter un commentaire

  • Pull back on the orange tab to release the battery.

Ajouter un commentaire

  • Pull the battery out.

Ajouter un commentaire

  • Locate the sliding button labeled "CF open" on the back of the camera.

  • Press and slide down the button labeled "CF open". The memory card cover will pop open.

Ajouter un commentaire

  • Push down on the black square button next to the memory card slot. This will release the memory card from the slot.

Ajouter un commentaire

  • Pull the memory card out of the memory card slot.

Ajouter un commentaire

  • Remove two 2.4mm Phillips screws from the right side of the camera.

Ajouter un commentaire

  • Remove two 2.4mm Phillips screws above the label on the bottom of the camera.

  • Remove two 2.8mm Phillips screws next to the tripod hole.

Ajouter un commentaire

  • Remove the two 3.2mm Phillips screws that are closer to the top and bottom edges of the camera.

  • Remove the two 3.8mm Phillips screws on either side of the strap base.

Ajouter un commentaire

  • Remove one 1.6mm Phillips screw from the above the CF open button on back of the camera.

Ajouter un commentaire

  • Gently pull the front casing from the camera.

  • The following items will either fall off or will be loose: the strap base, the gray rubber cover labeled "Digital A/V Out", and the black rubber piece over the view finder.

  • Remove the memory card cover by sliding down the CF open button and moving the pin.

Ajouter un commentaire

  • Gently pull the back casing from the camera.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tanya Malalang

Membre depuis le 12/01/2011

325 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 13-1, Forte Winter 2011 Membre de l'équipe Cal Poly, Team 13-1, Forte Winter 2011

CPSU-FORTE-W11S13G1

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 1

30 derniers jours : 3

Total : 1,586