Introduction

This guide explains the location of exterior screws and the process to remove the rear panel.

  1. Unscrew the three small screws on the bottom.
    • Unscrew the three small screws on the bottom.

    • remove the wrist strap

  2. Remove the screw in the CF compartment.
    • Remove the screw in the CF compartment.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Open the rubber Digital AV Out compartment flap. Pry the battery with the IFIXIT opening tool. Carefully pull out the battery with two fingers.
    • Open the rubber Digital AV Out compartment flap.

    • Pry the battery with the IFIXIT opening tool.

    • Carefully pull out the battery with two fingers.

    • Unscrew the two screws that are now visible.

  5. Starting from the bottom, carefully pull the casing off. The casing will now pivot at the top.
    • Starting from the bottom, carefully pull the casing off.

    • The casing will now pivot at the top.

    • There are three catches that hold the back casing to the body.

    • You may have to pull with some force. The rear panel will make a snapping noise when it separates from the body.

  6. The interior of the camera should look like this.
    • The interior of the camera should look like this.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Shalan Ertis

Membre depuis le 26/01/2010

62 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 14-40, Regan Winter 2010 Membre de l'équipe Cal Poly, Team 14-40, Regan Winter 2010

CPSU-REGAN-W10S14G40

5 membres

8 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 4

Total : 3,017