Introduction
If your lid has become warped over time, use this guide to replace it.
Ce dont vous avez besoin
-
-
-
Lift the lid of the Perfectea
-
Remove the two 12mm Phillips #2 screws located at the brim of the pot.
Demander à FixBot
-
-
-
-
With one hand, firmly grip the lid while designating your other hand to wedge the spudger between the lid and the glass pot.
-
Working from the outside to the inside, gently pry the adhesive tape from the glass pot, detaching the lid.
-
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
Équipe
Cal Poly, Team 6-17, Maness Spring 2015 Membre de l'équipe Cal Poly, Team 6-17, Maness Spring 2015
CPSU-MANESS-S15S6G17
4 membres
12 tutoriels rédigés
2 commentaires de tutoriel
This guide applies to the Capresso H2O kettle too. Thanks for the guide.
What kind of adhesive tape is it and where can I get some? That piece that you pried off had already fallen off of my kettle.
