Introduction

This guide shows how to remove the back case of the camera to replace a damaged back case or access the inner parts of the camera.

Pièces

Aucune pièce nécessaire.

  1. Locate 12 screws. Four on the left, four on the right, and four on the bottom. Locate 12 screws. Four on the left, four on the right, and four on the bottom. Locate 12 screws. Four on the left, four on the right, and four on the bottom.
    • Locate 12 screws. Four on the left, four on the right, and four on the bottom.

  2. Using the #00 Phillips screwdriver, remove the four 3.66mm screws from the bottom outer case, and the eight 1.75mm screw from the sides of the case.
    • Using the #00 Phillips screwdriver, remove the four 3.66mm screws from the bottom outer case, and the eight 1.75mm screw from the sides of the case.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Separate the front case from the body of the camera.
    • Separate the front case from the body of the camera.

  5. Separate the back case from the body of the camera.
    • Separate the back case from the body of the camera.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Laura

Membre depuis le 19/04/2012

31 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 9-45, Regan Spring 2012 Membre de l'équipe Cal Poly, Team 9-45, Regan Spring 2012

CPSU-REGAN-S12S9G45

7 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 421