Aller au contenu principal

Introduction

Follow this guide if you need to replace the heat sink of your Dell XPS 15 9570. You may need to complete this replacement if your computer is overheating or if you wish to apply more thermal paste.

Before starting this guide, power the laptop off and disconnect from the charger.

  1. Flip the device over so the base cover of the computer is facing upwards.
    • Flip the device over so the base cover of the computer is facing upwards.

  2. Using a Torx T5 screwdriver, remove the ten 3 mm screws on the back. Using a Torx T5 screwdriver, remove the ten 3 mm screws on the back. Using a Torx T5 screwdriver, remove the ten 3 mm screws on the back.
    • Using a Torx T5 screwdriver, remove the ten 3 mm screws on the back.

  3. Flip open the system badge and with a Phillips #00, remove the two 8.5 mm screws. Flip open the system badge and with a Phillips #00, remove the two 8.5 mm screws.
    • Flip open the system badge and with a Phillips #00, remove the two 8.5 mm screws.

  4. Lift the back cover off of the device.
    • Lift the back cover off of the device.

  5. Using the Phillips #00 screwdriver, remove the four 4 mm screws holding the battery in place.
    • Using the Phillips #00 screwdriver, remove the four 4 mm screws holding the battery in place.

  6. Use the iFixit opening tool to disconnect the battery connector from the motherboard.
    • Use the iFixit opening tool to disconnect the battery connector from the motherboard.

  7. With your hands, pick up and remove the battery from the system.
    • With your hands, pick up and remove the battery from the system.

  8. Use the Phillips #00 to remove the three 3 mm screws that connect the heat sink to the system board. Use the Phillips #00 to remove the three 3 mm screws that connect the heat sink to the system board.
    • Use the Phillips #00 to remove the three 3 mm screws that connect the heat sink to the system board.

  9. Lift the heat sink from the device.
    • Lift the heat sink from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Margaret Combs

Membre depuis le 08/09/2021

426 Réputation

4 tutoriels rédigés

Équipe

University of Alabama, Team 2-4, Bedsole Fall 2021 Membre de l'équipe University of Alabama, Team 2-4, Bedsole Fall 2021

UA-BEDSOLE-F21S2G4

3 membres

6 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 3

7 derniers jours : 18

30 derniers jours : 63

Total : 318